OBD-II (OBD-2) Parking Mode Power Cable Compatible with BlackVue X Series Dashcam | OBD-2 to DC 3pin Plug & Play | 3-Wire Hardwiring Cable Alternative | Compatible with Gas, Hybrid, Electric Vehicles

Product Name: OBD-II Power Cable Model Name: QK-OBD-BV-V1 Manufacture: Qkawa Compatibility: Compatible with BlackVue X Series Dashcam Compatible Vehicles: Gas, Hybrid, Electric Output: 12v only Length: 3.0m (9.8ft) Weight: 90g (3.18oz) Compatible Dashcam Models: Compatible with most BlackVue X Series dashcams with a 3-pin connector (Except for DR750X-2CH LTE Plus, DR750X-2CH LTE, and S Series with a 2-pin connector). Mode Switch Position: 24h (Default): After 24 hours in parking mode, power will be completely cut off to prevent car battery drain. ACC: Advanced users can obtain continuous power for vehicles with more than 2 batteries (Not recommended for most use cases). LED Idecator Status: Solid: Driving mode Flash: Parking mode Off: Completely cut off power After 24 hours to prevent car battery drain (24h mode) FAQ 1. Question: Should I use 24h or ACC mode? Answer: 24h mode is designed for normal use with 24-hour power cut-off protection. Only use ACC mode when your car has at least 2 batteries attached. 2. Do I need to set my "Battery Protection" in my dashcam setting? Answer: Yes, even with the 24h setting on the OBD-II Cable switch. In your dashcam settings, you still need to set the "Cut-off Timer" to 12 hours or less. This will give the dashcam another layer of protection and was also verified by experienced dashcam installers during our cable design phase. 3. Question: I hear the voice prompts "Normal mode" and "Parking mode on" several times while I am driving. Is this normal? Answer: Yes, it is normal since some vehicles may have this issue due to CAN Bus readings and OBD-II power glitches. And it will not affect the video recording.